Search results
Results From The WOW.Com Content Network
RS-422 is a common transport mechanism for RS-232 extenders. These consist of RS-232 ports on either end of an RS-422 connection. Before hard-disk-based playout and editing systems were used, broadcast automation systems and post-production linear editing facilities used RS-422A [ check spelling ] to remotely control the players/recorders ...
The electric signaling levels are handled by a driver circuit external to the UART. Common signal levels are RS-232, RS-485, and raw TTL [1] for short debugging links. Early teletypewriters used current loops. It was one of the earliest computer communication devices, used to attach teletypewriters for an operator console.
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.
Maximum user data rate, transmission data depending on driver and line of e.g. RS-422: 10 MHz, 1 km; LVDS: 100 Mbit/s Independent of the applied physical layer CRC secured communication (sensor data and control data secured separately) [ 8 ]
At the application layer, the standard also defines the contents of each sentence (message) type, so that all listeners can parse messages accurately. While NMEA 0183 only defines an RS-422 transport, there also exists a de facto standard in which the sentences from NMEA 0183 are placed in UDP datagrams (one sentence per packet) and sent over ...
It uses an DE-9 D-Sub connector with 9 pins (hence the name), where bi-directional communication takes place over a four wire cable according to the RS-422 standard. While nowadays all post-production editing is done with a non-linear editing system, in those days editing was done linearly, using online editing. Editing machines relied heavily ...
When you get a message from a "MAILER-DAEMON" or a "Mail Delivery Subsystem" with a subject similar to "Failed Delivery," this means that an email you sent was undeliverable and has been bounced back to you. These messages are sent automatically and often include the reason for the delivery failure.
RS-422 and RS-485 outputs can be implemented as differential TTL. [2] Normal TTL signals are single-ended, which means that each signal consists of a voltage on one wire, referenced to a system ground. [3] The "low" voltage level is zero to 0.8 volts, and the "high" voltage level is 2 volts to 5 volts.