Search results
Results From The WOW.Com Content Network
A trench marks the position at which the flexed, subducting slab begins to descend beneath another lithospheric slab. Trenches are generally parallel to and about 200 km (120 mi) from a volcanic arc. Much of the fluid trapped in sediments of the subducting slab returns to the surface at the oceanic trench, producing mud volcanoes and cold seeps.
Depth of oceanic trenches seems to be controlled by age of the oceanic lithosphere being subducted. [5] Sediment fill in oceanic trenches varies and generally depends on abundance of sediment input from surrounding areas. An oceanic trench, the Mariana Trench, is the deepest point of the ocean at a depth of approximately 11,000 m (36,089 ft).
Three types of plate boundary Convergent boundary Divergent boundary Transform boundary. Tectonic plate interactions are classified into three basic types: [1] Convergent boundaries are areas where plates move toward each other and collide. These are also known as compressional or destructive boundaries.
Continental-continental divergent/constructive boundary Oceanic divergent boundary: mid-ocean ridge (cross-section/cut-away view). In plate tectonics, a divergent boundary or divergent plate boundary (also known as a constructive boundary or an extensional boundary) is a linear feature that exists between two tectonic plates that are moving away from each other.
Oceanic trenches are the deepest parts of the ocean floor. Beyond the trench is the forearc portion of the overriding plate. Depending on sedimentation rates, the forearc may include an accretionary wedge of sediments scraped off the subducting slab and accreted to the overriding plate. However, not all arc-trench complexes have an accretionary ...
On the subducting side of the island arc is a deep and narrow oceanic trench, which is the trace at the Earth's surface of the boundary between the down-going and overriding plates. This trench is created by the downward gravitational pull of the relatively dense subducting plate on the leading edge of the plate.
At the triple junction each of the three boundaries will be one of three types – a ridge (R), trench (T) or transform fault (F) – and triple junctions can be described according to the types of plate margin that meet at them (e.g. fault–fault–trench, ridge–ridge–ridge, or abbreviated F-F-T, R-R-R).
A gas main being laid in a trench. A trench is a type of excavation or depression in the ground that is generally deeper than it is wide (as opposed to a swale or a bar ditch), and narrow compared with its length (as opposed to a simple hole or pit). [1] In geology, trenches result from erosion by rivers or by geological movement of tectonic ...