Ads
related to: random wire antenna length chart
Search results
Results From The WOW.Com Content Network
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
Assuming the building is about 20 feet tall, the length of wire seems to be on the order of 100 feet long – too short to be an HF Beverage antenna. Random wire antenna Moxon (1993) describes the random-wire antenna as an "odd bit of wire". [14] [page needed] It is the typical informal antenna erected for receiving shortwave and AM radio.
Moxon antenna for the 20-meter band.The antenna is the faint rectangle of wires held in tension by the bent X-shaped support frame. Moxon antenna for the 2-meter band. The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. [1]
The electrical length of an antenna, like a transmission line, is its length in wavelengths of the current on the antenna at the operating frequency. [ 1 ] [ 12 ] [ 13 ] [ 4 ] : p.91–104 An antenna's resonant frequency , radiation pattern , and driving point impedance depend not on its physical length but on its electrical length. [ 14 ]
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
A rhombic antenna is made of four sections of wire suspended parallel to the ground in a diamond or "rhombus" shape. Each of the four sides is the same length – about a quarter-wavelength to one wavelength per section – converging but not touching at an angle of about 42° at the fed end and at the far end.
For radials 9 electrical degrees or less ( 1 / 40 wavelength, each, or shorter) the effect on feedpoint impedance and the current in the mast is the same as extending the height of the antenna by a length of wire equal to 99% of the total length of all the radials, up to about a dozen radials.
In antennas built for frequencies near or below 600 kHz [b], the length of an antenna's wire segments is usually shorter than a quarter wavelength [c] [ 1 / 4 λ ≈ 125 m (410 feet) [c] at 600 kHz [b]], the shortest length of unloaded straight wire that achieves resonance. [5]