Ads
related to: other names for cracks in brick exterior of home construction area
Search results
Results From The WOW.Com Content Network
This joint design requires no tooling and is formed naturally as excess mortar is squeezed out from between the bricks. The result is a rustic, textured appearance. This design is not recommended for exterior building walls due to the tendency for exposed mortar to break away, degrading the wall’s appearance. Beaded joint
Air brick: A brick with perforations to allow the passage of air through a wall. Usually used to permit the ventilation of underfloor areas. Bat: A cut brick. A quarter bat is one-quarter the length of a stretcher. A half-bat is one-half. [1] Bullnose: Rounded edges are useful for window sills, and capping on low and freestanding walls.
Some contractors bring the mortar to the very edge, flush with the face of the brick. Others leave it recessed back to allow water to shed off the building. There are three types of recessed mortar: bucket handle, weatherstruck, and simply recessed. The bucket handle is when the mortar is in a curve shape away from the face of the brick.
Foundation crack injections are used when poured concrete foundations crack, either from settlement or the expansion and contraction of the concrete. Epoxy crack injections are typically used for structural purposes while hydrophobic or hydrophilic polyurethane injections are used to seal cracks to prevent penetration of moisture or water.
Although there are many types of anchors or anchorages, according to the Dictionary of Architecture and Construction, an anchor plate specifically is a "wrought-iron clamp, of Flemish origin, on the exterior side of a brick building wall that is connected to the opposite wall by a steel tie-rod to prevent the two walls from spreading apart ...
An alternative to latex exterior paints, limewash is better suited to brick, and it can give you full, paint-like coverage or a washed-out, historic appearance. But giving your house the limewash ...
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!