Search results
Results From The WOW.Com Content Network
NOP for the sub's setup time; Pull SCLK high; Left-Shift the next input bit from MISO into byte_in; NOP for the sub's hold time; Pull SCLK low; byte_in now contains that recently-received byte and can be used as desired; Pull CS high to unselect the sub; Bit-banging a sub's protocol is similar but different from above.
When the MAC drives the MDIO line, it has to guarantee a stable value 10 ns (setup time) before the rising edge of the clock MDC. Further, MDIO has to remain stable 10 ns (hold time) after the rising edge of MDC. When the PHY drives the MDIO line, the PHY has to provide the MDIO signal between 0 and 300 ns after the rising edge of the clock. [1]
Devices implementing SPI are typically specified with line rates of 700~800 Mbit/s and in some cases up to 1 Gbit/s. The latest version is SPI 4 Phase 2 also known as SPI 4.2 delivers bandwidth of up to 16 Gbit/s for a 16 bit interface. The Interlaken protocol, a close variant of SPI-5 replaced the System Packet Interface in the marketplace.
The timing diagram example on the right describes the Serial Peripheral Interface (SPI) Bus. Most SPI master nodes can set the clock polarity (CPOL) and clock phase (CPHA) with respect to the data. This timing diagram shows the clock for both values of CPOL and the values for the two data lines (MISO & MOSI) for each value of CPHA.
Parallel SCSI (formally, SCSI Parallel Interface, or SPI) is the earliest of the interface implementations in the SCSI family. SPI is a parallel bus ; there is one set of electrical connections stretching from one end of the SCSI bus to the other.
An example SPI with a master and three slave select lines. Note that all four chips share the SCLK, MISO, and MOSI lines but each slave has its own slave select. Chip select (CS) or slave select (SS) is the name of a control line in digital electronics used to select one (or a set) of integrated circuits (commonly called "chips") out of several connected to the same computer bus, usually ...
Setup time is the minimum amount of time the data input should be held steady before the clock event, so that the data is reliably sampled by the clock. Hold time is the minimum amount of time the data input should be held steady after the clock event, so that the data is reliably sampled by the clock. Aperture is the sum of setup and hold time ...
This requires the PCB to be designed to add a 1.5–2 ns delay to the clock signal to meet the setup and hold times on the sink. RGMII v2.0 specifies an optional internal delay, obviating the need for the PCB designer to add delay; this is known as RGMII-ID.