Search results
Results From The WOW.Com Content Network
One or more logical or physical interfaces may have a VRF and these VRFs do not share routes. Therefore, the packets are only forwarded between interfaces on the same VRF. VRFs are the TCP/IP layer 3 equivalent of a VLAN. Because the routing instances are independent, the same or overlapping IP addresses can be used without conflicting with ...
If a DHCP client outside the DHCP server's subnet broadcasts an address request, it is the helper that forwards the message to the DHCP server. The server then chooses an address and sends the client a unicast message, using the helper to send the message back to the client's subnet. The address is reserved for a limited time while the DHCP ...
Local port forwarding is the most common type of port forwarding. It is used to let a user connect from the local computer to another server, i.e. forward data securely from another client application running on the same computer as a Secure Shell (SSH) client. By using local port forwarding, firewalls that block certain web pages, can be ...
Allow traffic to be routed between VLANs by providing a default gateway for the VLAN. Provide fallback bridging (if required for non-routable protocols). Provide Layer 3 IP connectivity to the switch. Support bridging configurations and routing protocol. Access Layer - 'Routed Access' Configuration (in lieu of Spanning Tree) SVIs advantages ...
On the early Cisco AGS+ and 7000, for example, the forwarding processor cache could hold approximately 1000 route entries. In an enterprise, this would often work quite well, because there were fewer than 1000 server or other popular destination subnets. Such a cache, however, was far too small for general Internet routing.
In this case the switch marks the frame for flooding and sends it to all forwarding ports within the respective VLAN. Forwarding this type of traffic can create unnecessary traffic that leads to poor network performance or even a complete loss of network service. [6] This flooding of packets is known as a unicast flooding. [7] [5]
The difference between a layer-3 switch and a router is the way the device is making the routing decision. Conventionally, routers use microprocessors to make forwarding decisions in software, while the switch performs only hardware-based packet switching (by specialized ASICs with the help of content-addressable memory).
Routing is the process of selecting a path for traffic in a network or between or across multiple networks. Broadly, routing is performed in many types of networks, including circuit-switched networks , such as the public switched telephone network (PSTN), and computer networks , such as the Internet .