Search results
Results From The WOW.Com Content Network
This block is one of three displacements, 302/327/350, that underwent a crankshaft bearing diameter transformation for 1968 when the rod-journal size was increased from the 2 in (50.8 mm) diameter small-journal to a 2.1 in (53.3 mm) large-journal and a main-journal size that was increased from 2.3 in (58.4 mm) to 2.45 in (62.2 mm).
Ceramic mold casting, also known ambiguously as ceramic molding, [1] is a group of metal casting processes that use ceramics as the mold material. It is a combination of plaster mold casting and investment casting. [2] [3] There are two types of ceramic mold casting: the Shaw process and the Unicast process. [4]
Pontiac differed from other GM Divisions and most other manufacturers in producing only a single sized V8 casting, rather than adding a larger big block to its line-up. The external dimensions of all their V8s, from 326–455 cu in (5.3–7.5 L) were the same. Engine displacement is a function of bore and stroke.
Typical products made using this process are television tubes and missile nose cones. [citation needed] Spin casting is also used to manufacture large telescope mirrors, where the natural curve followed by the molten glass greatly reduces the amount of grinding required. Rather than pouring glass into a mold an entire turntable containing the ...
Permanent mold casting is a metal casting process that employs reusable molds ("permanent molds"), usually made from metal. The most common process uses gravity to fill the mold. However, gas pressure or a vacuum are also used. A variation on the typical gravity casting process, called slush casting, produces hollow castings.
Centrifugal casting (industrial) Continuous casting; Die casting; Evaporative-pattern casting. Full-mold casting; Lost-foam casting; Investment casting (Lost-wax casting) Countergravity casting [1] Lost-foam casting; Low pressure die casting; Permanent mold casting; Plastic mold casting; Resin casting; Sand casting; Shell molding; Slush casting ...
De Dion-Bouton engine with monobloc cylinder heads, but cylinders separate from crankcase c. 1905 [1]. A monobloc or en bloc engine is an internal-combustion piston engine some of whose major components (such as cylinder head, cylinder block, or crankcase) are formed, usually by casting, as a single integral unit, rather than being assembled later.
Evaporative-pattern casting is a type of casting process that uses a pattern made from a material that will evaporate when the molten metal is poured into the molding cavity. The most common evaporative-pattern material used is polystyrene foam. [1] The two major evaporative-pattern casting processes are: [1] Lost-foam casting; Full-mold casting