Search results
Results From The WOW.Com Content Network
In electronics and telecommunications, jitter is the deviation from true periodicity of a presumably periodic signal, often in relation to a reference clock signal. In clock recovery applications it is called timing jitter. [1] Jitter is a significant, and usually undesired, factor in the design of almost all communications links.
Jitter is often measured as a fraction of UI. For example, jitter of 0.01 UI is jitter that moves a signal edge by 1% of the UI duration. The widespread use of UI in jitter measurements comes from the need to apply the same requirements or results to cases of different symbol rates. This can be d
It is used to specify clock stability requirements in telecommunications standards. [1] MTIE measurements can be used to detect clock instability that can cause data loss on a communications channel. [ 2 ]
The counter implementation's accuracy is limited by the clock frequency. If time is measured by whole counts, then the resolution is limited to the clock period. For example, a 10 MHz clock has a resolution of 100 ns. To get resolution finer than a clock period, there are time interpolation circuits. [6]
Generalized Timing Formula is a standard by VESA which defines exact parameters of the component video signal for analogue VGA display interface.. The video parameters defined by the standard include horizontal blanking (retrace) and vertical blanking intervals, horizontal frequency and vertical frequency (collectively, pixel clock rate or video signal bandwidth), and horizontal/vertical sync ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
Reference clock jitter translates directly to the output, but this jitter is a smaller percentage of the output period (by the ratio above). Since the maximum output frequency is limited to f c l k / 2 {\displaystyle f_{clk}/2} , the output phase noise at close-in offsets is always at least 6 dB below the reference clock phase noise.
The duty cycle is defined as the ratio between the pulse duration, or pulse width and the period of a rectangular waveform Spectrum in relation to duty cycle. A duty cycle or power cycle is the fraction of one period in which a signal or system is active.