Search results
Results From The WOW.Com Content Network
In 1953, the "Park Plant" was built, a one-story, 125,000-square-foot (11,600 m 2) building in nearby Loves Park. In 1954, the company purchased the Hendey Machine Company. By 1965, three other additions were complete on the Loves Park facility. In 1968, a 200,000-square-foot (19,000 m 2) facility was built just north of the original plant. By ...
Not all stationary wire-tying balers used two wires. It was not uncommon for the larger bale size – usually 17 in × 22 in (43 cm × 56 cm) – machines to use 'boards' that had three slots for wires and hence tied three wires per bale. Most North American manufacturers produced these machines as either regular models or as size options.
"Not only is it lights-out," says Fanuc vice president Gary Zywiol, "we turn off the air conditioning and heat too." [6] [7] In the Netherlands, Philips uses lights-out manufacturing to produce electric razors, with 128 robots made by Adept Technology. There are only nine human quality assurance workers who oversee the end of the manufacturing ...
The seed drill sows the seeds at the proper seeding rate and depth, ensuring that the seeds are covered by soil. This saves them from being eaten by birds and animals, or being dried up due to exposure to the sun. With seed drill machines, seeds are distributed in rows; this allows plants to get sufficient sunlight, nutrients from the soil.
The sequence of events is similar for manual or automatic synchronization. The generator is brought up to approximate synchronous speed by supplying more energy to its shaft - for example, opening the valves on a steam turbine, opening the gates on a hydraulic turbine, or increasing the fuel rack setting on a diesel engine.
A tree baler is a machine that wraps trees to allow for easier shipment and storage. Wrapped trees take up much less space and are less likely to be damaged during shipment. [ 1 ] The aim of the device is to replace work that previously required hand-tying individual trees, most often used at commercial nurseries .
There were problems with using wire [3] and it was not long before William Deering invented a binder that successfully used twine and a knotter (invented in 1858 by John Appleby). [ 4 ] Early binders were horse-drawn, their cutting and tying-mechanisms powered by a bull-wheel, that through the traction of being pulled forward creates rotational ...
Traditionally, an operator would plant at about 4.5-5.5 mph for optimal performance. However, with the advent of these systems electrical motors match the speed of the tractor and "dead-drop" the seed in the trench using either a belt or brush-belt which cause the forward momentum of the planter to be offset by the rearward momentum of the seed.