Ads
related to: 2m 70cm yagi measurements images size comparison guide
Search results
Results From The WOW.Com Content Network
Similar to how a vertical monopole uses its ground system to produce a "phantom" image of the rest of a dipole, the missing lower half of the half-loop is replaced by its image in the ground-plane. If shaped like a half of a square, a half-loop can operate either as a loop antenna or on its first harmonic as a dipole antenna whose ends have ...
A Yagi–Uda antenna, or simply Yagi antenna, is a directional antenna consisting of two or more parallel resonant antenna elements in an end-fire array; [1] these elements are most often metal rods (or discs) acting as half-wave dipoles. [2]
The gain and input impedance of the antenna is dependent on the length of the whip element, compared to a wavelength, but also on the size and shape of the ground plane used (if any). A quarter wave vertical antenna working against a perfectly conducting, infinite ground will have a gain of 5.19 dBi and a radiation resistance of about 36.8 ohms.
Antenna measurement techniques refers to the testing of antennas in order to ensure that the antenna meets specifications or simply to characterize it. Typical antenna parameters are gain , bandwidth , radiation pattern , beamwidth , polarization , impedance ; These are imperative communicative means.
How much of that power has actually been radiated cannot be directly determined through electrical measurements at (or before) the antenna terminals, but would require (for instance) careful measurement of field strength. The loss resistance and efficiency of an antenna can be calculated once the field strength is known, by comparing it to the ...
The relative scale-size k ranges from about 0.98 for thin wires (diameter, 0.00001 wave) to about 0.94 for thick conductors (diameter, 0.008 wave). This is because the effect of antenna length on reactance (upper graph) is much greater for thinner conductors so that a smaller deviation from the exact half wavelength is required in order to ...
Yagi_uda_antenna.jpg (299 × 500 pixels, file size: 108 KB, MIME type: image/jpeg) This is a file from the Wikimedia Commons . Information from its description page there is shown below.
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.