Search results
Results From The WOW.Com Content Network
Generally the thicker the string, the shorter the effective length. This refers to the length of string involved in producing a sound, as opposed to the length between the nut and the bridge. Many guitar designs with fixed bridges have the bridge slanted or stepped so that the distance from the nut to the bridge is larger for thick strings.
This is an important adjustment especially when changing the gauge of the string set on the guitar. There are practical limits to this technique: too high and it could bend the posts and the strings will not seat properly into the bridge saddles; too low and the string break will rest on the rear of the bridge, killing sustain and tone.
Truss rods are frequently made out of steel, though graphite and other materials are sometimes used.. The truss rod can be adjusted to compensate for expansion or contraction in the neck wood due to changes in humidity or temperature, or to compensate for changes in the tension of the strings (the thicker the guitar string, the higher its tension when tuned to correct pitch) or using different ...
On a typical steel string acoustic guitar, for example, the action is adjusted by carefully sanding the guitar's saddle so that the strings sit closer to the fretboard. [1] The action on a guitar is also slightly affected by the adjustment of the truss rod. Tightening the truss rod bends the neck backwards, lowering the action—and loosening ...
Acoustic fretted instruments typically have either a floating bridge, held in place by string tension, or a fixed bridge, such as a pin bridge on an acoustic guitar. A luthier or technician adjusts a floating bridge simply by carefully changing its position until the intonation is correct. Adjusting intonation on a fixed bridge involves ...
The guitar tech also might perform any of a variety of maintenance tasks, such as checking that the string height of the guitars is set properly, modifying ("dressing") the height and arc of the frets, adjusting the intonation of the instruments, checking that tubes (valves) on tube amplifiers are working properly, and that cables are in good condition and free from crackles and hum caused by ...
The System I bridge string height is set by adjustable pivot post screws and has no individual string height adjustments but has individual string intonation adjustments and is very much like the Gibson Tune-o-matic bridge in terms of intonation and string height adjustments. The System I tremolo system uses a behind the nut string locking ...
One end is pierced for the string; the other is squared off to fit in a tuning lever socket. The middle section, which would pass through the wood, is tapered. A variety of methods are used to tune different stringed instruments. Most change the pitch produced when the string is played by adjusting the tension of the strings.