Ad
related to: watts to dbm conversion
Search results
Results From The WOW.Com Content Network
The decibel watt (dBW or dB W) is a unit for the measurement of the strength of a signal expressed in decibels relative to one watt.It is used because of its capability to express both very large and very small values of power in a short range of number; e.g., 1 milliwatt = −30 dBW, 1 watt = 0 dBW, 10 watts = 10 dBW, 100 watts = 20 dBW, and 1,000,000 W = 60 dBW.
1 dB = 1 / 20 ln 10 is the decibel. The commonly used reference sound power in air is [11] = . The proper notations for sound power level using this reference are L W/(1 pW) or L W (re 1 pW), but the suffix notations dB SWL, dB(SWL), dBSWL, or dB SWL are very common, even if they are not accepted by the SI. [12]
Many high-quality domestic speakers have a sensitivity between ~84 dB and ~94 dB, but professional speakers can have a sensitivity between ~90 dB and ~100 dB. An '84 dB' source would require a 400-watt amplifier to produce the same acoustical power (perceived loudness) as a '90 dB' source being driven by a 100-watt amplifier, or a '100 dB ...
dBm or dB mW (decibel-milliwatts) is a unit of power level expressed using a logarithmic decibel (dB) scale respective to one milliwatt (mW). It is commonly used by radio, microwave and fiber-optical communication technicians & engineers to measure the power of system transmissions on a log scale , which can express both very large and very ...
The unit dB FS or dBFS is defined in AES Standard AES17-1998, [13] IEC 61606, [14] and ITU-T Recs. P.381 [15] and P.382, [16] such that the RMS value of a full-scale sine wave is designated 0 dB FS. This means a full-scale square wave would have an RMS value of +3 dB FS.
Let us assume a 100 watt (20 dB W) transmitter with losses of 6 dB prior to the antenna. ERP < 22.77 dB W and EIRP < 24.92 dB W, both less than ideal by η in dB. Assuming that the receiver is in the first side-lobe of the transmitting antenna, and each value is further reduced by 7.2 dB, which is the decrease in directivity from the main to ...
The SI unit of intensity, which includes sound intensity, is the watt per square meter (W/m 2). One application is the noise measurement of sound intensity in the air at a listener's location as a sound energy quantity. [3] Sound intensity is not the same physical quantity as sound pressure. Human hearing is sensitive to sound pressure which is ...
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...