Search results
Results From The WOW.Com Content Network
A charge controller, charge regulator or battery regulator limits the rate at which electric current is added to or drawn from electric batteries to protect against electrical overload, overcharging, and may protect against overvoltage. [1] [2] This prevents conditions that reduce battery performance or lifespan and may pose a safety risk. It ...
The cut-off voltage is different from one battery to the other and it is highly dependent on the type of battery and the kind of service in which the battery is used. When testing the capacity of a NiMH or NiCd battery a cut-off voltage of 1.0 V per cell is normally used, whereas 0.9 V is normally used as the cut-off voltage of an alkaline cell ...
While the state of charge is usually expressed using percentage points (0 % = empty; 100 % = full), depth of discharge is either expressed using units of Ah (e.g. for a 50 Ah battery, 0 Ah is full and 50 Ah is empty) or percentage points (100 % is empty and 0 % is full). The capacity of a battery may also be higher than its nominal rating.
Battery Charging Specification 1.1 specifies that charging devices must dynamically limit bus power current draw during High Speed signaling; [53] 1.2 specifies that charging devices and ports must be designed to tolerate the higher ground voltage difference in High Speed signaling. Revision 1.2 of the specification was released in 2010.
Trickle charging is the process of charging a fully charged battery at a rate equal to its self-discharge rate, enabling the battery to remain at its fully charged level. This state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load.
Power Delivery provides the ability for 5 V devices to draw more than 7.5 W of power (the limit specified by USB Battery Charging) from USB PD-aware ports when using PD-aware USB cables. The specification also allows PD ports to provide even greater power at higher voltages over PD-aware cables; up to 36 W at 12 V and 60 W at 20 V (for micro ...
A battery balancer or regulator is an electrical device in a battery pack that performs battery balancing. [2] Circuitry that includes designs to balance cell charges during battery pack recharging may be either active or passive in its design, [ 3 ] and is most often found in lithium-ion batteries , [ 4 ] e.g., for laptop computers, electrical ...
Charging a 12 V lead–acid car battery A mobile phone plugged in to an AC adapter for charging. A battery charger, recharger, or simply charger, [1] [2] is a device that stores energy in an electric battery by running current through it.