Search results
Results From The WOW.Com Content Network
Draw reins in the western riding disciplines are always attached to the rings of the cinch (a western-style girth), usually on each side of a western saddle, run through the bit rings (either inside to outside or vice versa, there is no firm rule, though the rein moves more smoothly if the inside goes to the girth and the outside to the hand), and then to the hands of the rider.
Reins are used to direct a horse (or other animal) when riding or driving. They are attached to a bridle 's bit or noseband and are made of leather , nylon , or other materials. Reins are used to give subtle commands or cues—also known as rein aids —to ask for a turn, a slower speed, a halt, or to go backwards .
A terret or rein ring is a metal loop on a horse harness through which the lines (reins) pass to prevent them from tangling or getting snagged on the harness or shafts. [ 1 ] : 272 The lines run from the hands of the driver, through the terrets, and then attach to the horse 's bit to guide the horse.
Reins are the means by which a horse rider or driver communicates directional commands to the horse's head. Pulling on the reins can be used to steer or stop the horse. The sides of a horse's mouth are sensitive, so pulling on the reins pulls the bit, which then pulls the horse's head from side to side, which is how the horse is controlled.
Note the rings that go around each of the reins, and the rein stops between the martingale rings and the bit rings. The running martingale consists of a strap which is attached to the girth and passes between the horse's front legs before dividing into two pieces. At the end of each of these straps is a small metal ring through which the reins ...
"Narrow-back rein holders" were probably hung to the rider's waist. They worked as rein hooks, attached at the belt, for horse control. [4] "Broad-back rein holders" were probably fixed at the leading edge of the carriage to hold the reins. [3] They may also have been attached at the belt of the charioter for hands-free control. [5] [6]
The noseband and curb chain are connected by a metal link that also includes the long shank that applies pressure to the nose, chin groove and poll when the reins are tightened. The mechanical hackamore is unrelated to a hackamore except to the extent that both are headgear that control a horse with some form of noseband rather than a bit in ...
A modern harness with an overcheck rein, visible along the neck of the horse. A bearing rein, also known as an overcheck or a checkrein, is a piece of horse harness that runs from a point on the horse's back, over the head, to a bit. It is used to prevent the horse from lowering its head beyond a fixed point.