Search results
Results From The WOW.Com Content Network
Tactile sound is often used in combination with a subwoofer so that low frequencies can be both felt and heard. To facilitate broadband tactile sound, all channels are summed to provide a full range signal to the transducer amplifier. Graphic equalizers can also be used to further modify the effect.
They can result from improper clock sources [3] and buffer size. Also, clicks can be caused by electric devices near the computer or by faulty audio or mains cables. [4] In sample recording, digital clicks occur when the signal levels of two adjacent audio sections do not match. The abrupt change in gain can be perceived as a click. [5]
Using a low-frequency oscillation signal as a means of modulating another signal introduces complexities into the resulting sound, such that a variety of effects can be achieved. The specifics vary greatly depending on the type of modulation, the relative frequencies of the LFO signal and the signal being modulated, et cetera.
The power supply voltage changes will appear in the input stage as positive feedback. An example is a transistor radio which plays well with a fresh battery, but squeals or "motorboats" when the battery is old. In audio systems, if a microphone is placed close to a loudspeaker, parasitic oscillations may occur.
Different types of noise are generated by different devices and different processes. Thermal noise is unavoidable at non-zero temperature (see fluctuation-dissipation theorem), while other types depend mostly on device type (such as shot noise, [1] [3] which needs a steep potential barrier) or manufacturing quality and semiconductor defects, such as conductance fluctuations, including 1/f noise.
In other words, first the low-frequency signal is shifted to high frequency by multiplying it with high-frequency carrier, and it is given to the device affected by the flicker noise. The output of the device is again multiplied with the same carrier, so the previous information signal comes back to baseband, and flicker noise will be shifted ...
Infrasound arrays at monitoring station in Qaanaaq, Greenland.. Infrasound, sometimes referred to as low frequency sound or subsonic, describes sound waves with a frequency below the lower limit of human audibility (generally 20 Hz, as defined by the ANSI/ASA S1.1-2013 standard). [1]
Frequency drift was a problem in early (or inexpensive) receivers; inadequate selectivity may affect any tuner. A wideband FM signal can also be used to carry a stereo signal; this is done with multiplexing and demultiplexing before and after the FM process. The FM modulation and demodulation process is identical in stereo and monaural processes.