Search results
Results From The WOW.Com Content Network
When equipped with the 289 "HiPo" engine and a 4.11 rear axle ratio, the 1965 Mustang achieved 0–60 mph (0–97 km/h) in 5.2 seconds and a 1 ⁄ 4 mile (402 m) time of 14.0 seconds at 100 mph (161 km/h). [34] The 1966 Mustang debuted with moderate trim changes including a new grille, side ornamentation, wheel covers, and gas cap.
These suspension upgrades were included in the 1964 model year, before Chevrolet completely redesigned the suspension with a fully independent setup, when the second generation was released in 1965. GM's attempts to discredit Nader further brought negative publicity, at the same time that the Ford Mustang was putting significant strain on ...
A simple MacPherson strut suspension on the left front wheel of a rear-wheel drive vehicle. The front of the vehicle is at bottom right of the image. Upper green: Vehicle body/strut interface Red: Steering knuckle or hub carrier Blue: Lower control arm or track control arm Light blue: Steering gear tie rod or track rod Lower purple: Radius rod
Acceleration was impressive, with a 0-to-60 time of around seven seconds and a top speed of 140 miles per hour (230 km/h). Braking duties were handled by 11.3-inch discs up front and drums in the rear. Power assist was standard. The front suspension consisted of unequal-length control arms, coil springs, adjustable tube arms, and an anti-sway bar.
The Mustang II was 490 lb (222 kg) lighter and almost 19 in (483 mm) shorter than the 1973 Mustang, and derived from the subcompact Pinto platform. While sharing a limited number of driveline components with the Pinto, the Mustang II employed an exclusive subframe, isolating its front suspension and engine mount subframe.
From 1965 until 2004, the Mustang shared chassis commonality with other Ford model lines, staying rear-wheel-drive throughout its production. From 1965 to 1973, the Mustang was derived from the 1960 Ford Falcon compact. From 1974 until 1978, the Mustang (denoted Mustang II) was a longer-wheelbase version of the Ford Pinto.
Pfadt Racing Industry Automotive Founder Aaron Pfadt Headquarters Salt Lake City, United States Products GM aftermarket performance parts Owner Aaron Pfadt Pfadt Race Engineering is an engineering firm situated in Salt Lake City, Utah. History The company subsequently introduced new suspension lines for the Camaro and Cadillac ATS. Additionally, it launched exhaust headers specifically ...
The Mustang GT features a stiffer, better handling version of the standard suspension, larger 12.4-inch front brake discs (versus the 11.4-inch discs used on V6 Mustangs), standard four-channel ABS with traction control, a two-piece drive shaft, a stainless steel dual exhaust, standard grille-mounted fog lights, and 17-inch wheels, with ...