When.com Web Search

  1. Ads

    related to: idle air control valve fix on chevy

Search results

  1. Results From The WOW.Com Content Network
  2. Idle air control actuator - Wikipedia

    en.wikipedia.org/wiki/Idle_air_control_actuator

    An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.

  3. Throttle - Wikipedia

    en.wikipedia.org/wiki/Throttle

    Throttle bodies may also contain valves and adjustments to control the minimum airflow during idle. Even in those units that are not " drive-by-wire ", there will often be a small solenoid driven valve , the Idle Air Control Valve (IACV), that the ECU uses to control the amount of air that can bypass the main throttle opening to allow the ...

  4. Electronic throttle control - Wikipedia

    en.wikipedia.org/wiki/Electronic_throttle_control

    A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]

  5. Throttle position sensor - Wikipedia

    en.wikipedia.org/wiki/Throttle_position_sensor

    A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.

  6. MAP sensor - Wikipedia

    en.wikipedia.org/wiki/MAP_sensor

    The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and then monitor the MAP sensor's values. If the EGR is functioning properly, the ...

  7. Secondary air injection - Wikipedia

    en.wikipedia.org/wiki/Secondary_air_injection

    A sensitive reed valve assembly called the aspirator valve is placed in the air injection pumping, which draws its air directly from the clean side of the air filter. During engine idle, brief but periodic negative pressure pulses in the exhaust system draw air through the aspirator valve and into the exhaust stream at the catalytic converter.