Search results
Results From The WOW.Com Content Network
A push switch (button) is a momentary or non-latching switch which causes a temporary change in the state of an electrical circuit only while the switch is physically actuated. An automatic mechanism (i.e. a spring ) returns the switch to its default position immediately afterwards, restoring the initial circuit condition.
The most common type is a "push-to-make" (or normally-open or NO) switch, which makes contact when the button is pressed and breaks when the button is released. Each key of a computer keyboard, for example, is a normally-open "push-to-make" switch. A "push-to-break" (or normally-closed or NC) switch, on the other hand, breaks contact when the ...
A latching switch is a switch that maintains its state after being activated. [1] A push-to-make, push-to-break switch would therefore be a latching switch – each time you actuate it, whichever state the switch is left in will persist until the switch is actuated again. [2]
Typically starters are operated by two push switches, a "start" switch which is normally-off (i.e. push-to-make) and a "stop" switch which is normally-on (i.e. push-to-break). When the motor is not running, although line voltage is available, no current is drawn by the starter or motor.
Senate confirmation hearings set to begin this week are likely to reveal a defining trait uniting Donald Trump’s incoming Cabinet, regardless of their diverse political backgrounds and uneven ...
Tottenham midfielder Rodrigo Bentancur declared himself “all good” after being carried off on a stretcher during the English League Cup semifinal against Liverpool. Bentancur fell to the ...
"Jackie followed Artemis’ advice," she shared. "Onassis and Maria were twin (flames). They couldn’t separate from each other." According to Biography.com, Callas and Onassis met at a party in ...
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...