Ads
related to: hydraulic chuck clamping pressure gauge chart
Search results
Results From The WOW.Com Content Network
Commonly used for holding silicon wafers during lithography processes, an electrostatic chuck comprises a metal base-plate and a thin dielectric layer; the metal base-plate is maintained at a high-voltage relative to the wafer, and so an electrostatic force clamps the wafer to it. Electrostatic chucks may have pins, or mesas, the height of ...
Drawbar force gauges are able to detect broken or weakening components of the drawbar clamping system, can give indications that the unit needs lubrication, detect gripper mis-adjustment, or demonstrate that the incorrect retention knob is being used for the machine. A retention knob is a device screwed into the narrow end of a tool holder ...
The air pressure system consists of 4 components: air hose, air inflation gauge, inflation pedal and manual pressure bleed valve. The air hose is located near the top of the tire changer, and it allows compressed air to travel into the tire. A specialized end is used on the air hose to clamp firmly onto valve stems of the wheels. The air ...
Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.
This pressure is then transmitted to a hydraulic pressure gauge via a high pressure hose. [4] The gauge's Bourdon tube senses the pressure and registers it on the dial. Because this sensor has no electrical components, it is ideal for use in hazardous areas. [5] Typical hydraulic load cell applications include tank, bin, and hopper weighing. [6]
Matter-Additive, Matter-Preserving, and Matter-Subtractive "Manufacturing" can proceed in sixteen ways: Firstly, the work may be held either in a hand, or a clamp; secondly, the tool may be held either in a hand, or a clamp; thirdly, the energy can come from either the hand(s) holding the tool and/or the work, or from some external source ...