Search results
Results From The WOW.Com Content Network
The first recall was announced on February 7, 2014, and involved about 800,000 Chevrolet Cobalts and Pontiac G5s. [1] On March 31, GM announced it was going to recall over 1.5 million more cars of six different models, due to faulty power steering. Of these, over 1.3 million were in the United States, and three of the models were also involved ...
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
The Duraspark II ignition system is a common upgrade [1] for older Ford cars equipped with a points-type ignition. In most cases, the distributor will interchange with the older-style points distributor. The system is similar to some aftermarket systems [2] and the control module may be easily swapped. Duraspark swaps are easy and can be run by ...
The first engine to bear the Power Stroke name, the 7.3 L Power Stroke V8 is the Ford version of the Navistar T444E turbo-diesel V8. Introduced in 1994 as the replacement for the 7.3 L IDI V8, the Power Stroke/T444E is a completely new design, with only its bore and stroke dimensions common with its predecessor (resulting in its identical 444 ...
The contact breaker is operated by an engine-driven cam.On an engine with a distributor, the contact breaker can be found beneath the distributor cap.The position of the contact breaker is set so that it opens (and hence generates a spark) at exactly the optimum moment to ignite the fuel/air mixture.
The ignition source of a diesel engine is the heat generated by the compression of the air in the cylinder, rather than a spark as in gasoline engines. The dieseling phenomenon occurs not just because the compression ratio is sufficient to cause auto-ignition of the fuel, but also because a hot spot inside the cylinder (spark plug electrode ...
Low-speed pre-ignition (LSPI), also known as stochastic pre-ignition (SPI), [1] is a pre-ignition event that occurs in gasoline vehicle engines when there is a premature ignition of the main fuel charge. [2] LSPI is most common in certain turbocharged direct-injection vehicles operating in low-speed and high-load driving conditions. [3]