Ad
related to: difference between ethernet and serial
Search results
Results From The WOW.Com Content Network
Several factors allow serial to be clocked at a higher rate: Clock skew between different channels is not an issue (for unclocked asynchronous serial communication links). This can be caused by mismatched wire or conductor lengths. [17] [18] A serial connection requires fewer interconnecting cables (e.g., wires/fibers) and hence occupies less ...
Throughout most of the history of personal computers, data has been transferred through serial ports to devices such as modems, terminals, various peripherals, and directly between computers. While interfaces such as Ethernet , FireWire , and USB also send data as a serial stream , the term serial port usually denotes hardware compliant with RS ...
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
Ethernet initially competed with Token Ring and other proprietary protocols. Ethernet was able to adapt to market needs, and with 10BASE2 shift to inexpensive thin coaxial cable, and from 1990 to the now-ubiquitous twisted pair with 10BASE-T. By the end of the 1980s, Ethernet was clearly the dominant network technology. [4]
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
The current version of the standard is TIA-232-F Interface Between Data Terminal Equipment and Data Circuit-Terminating Equipment Employing Serial Binary Data Interchange, issued in 1997. The RS-232 standard had been commonly used with serial ports and serial cables. It is still widely used in industrial communication devices.
The serial gigabit media-independent interface (SGMII) is a variant of MII used for Gigabit Ethernet but can also carry 10/100 Mbit/s Ethernet. It uses differential pairs at 625 MHz clock frequency DDR for TX and RX data and TX and RX clocks. It differs from GMII by its low-power and low pin-count 8b/10b-coded SerDes. Transmit and receive path ...