Search results
Results From The WOW.Com Content Network
The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 engines had larger ports and valves than ...
It was a higher-performance version of the base 350 cu in (5.7 L) V8 with casting number 186, 2.02 / 1.6 in (51.3 / 40.6 mm) valve heads and had an 11.0:1 compression ratio requiring high octane gas. This produced 350 hp (261 kW) (SAE gross power) and 380 lb⋅ft (515 N⋅m) torque. [ 22 ]
The 301.6-cubic-inch (4.9 L) GMC inline six was produced from 1952 to 1960, when it was replaced by the V6. It has a square bore/stroke ratio of 4 by 4 inches (101.6 mm × 101.6 mm). This is the largest raised-deck engine. It was originally designed for the GMC military M135 and M211.
The 6.6L RPO LML (VIN code "8") is the 2011–2016 version of the Isuzu/GM Duramax V8 diesel engine. It is a further advanced version of the LMM engine with the majority of the changes addressing a required drastic reduction in engine emissions.
This newly revised engine put out 65 hp (48 kW), and was produced until 1936, with compression rates between 5.2:1 to 6:1. [3] Toyota's first engine, the Type A, produced from 1935 to 1947, was a reverse engineered copy of the 207 Chevrolet engine, with 62 hp (46 kW) power output and 94 percent of the compression ratio of the Chevrolet original ...
A typical oil change used 7.5–8 US qt (7.1–7.6 L; 6.2–6.7 imp qt) of oil. GM specified cast-iron cylinder liners and the cast aluminum pistons included valve clearance. Northstar is an interference engine: the valves will strike the pistons if they lose timing. It has bronze piston pin bushings and free-floating piston pins. GM used cast ...
It has a 10.3:1 compression ratio. Its fuel economy is 4–6 km/L (11–17 mpg ‑imp; 9.4–14.1 mpg ‑US) in city, and 7–9 km/L (20–25 mpg ‑imp; 16–21 mpg ‑US) on highway. [citation needed]. Holden also produced the 3.2L engines that were used by Alfa Romeo as the basis of its JTS V6 engine. Applications:
Stamped ball-pivot stud-mounted rocker arms were introduced, similar to the V8, with a 1.75:1 ratio, rather than the earlier shaft-mounted 1.477:1 rockers. The first use of the new engine series was the 194 cu in (3.2 L) Hi-Thrift version in the 1962 Chevy II ; the following year, Chevrolet passenger cars adopted the 230 cu in (3.8 L) version ...