Ads
related to: bose sounddock 10 no power cord attached with wiretemu.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
The first generation SoundDock was introduced in 2004. [19] It included a remote control and allowed all of the iPods controls to be used while docked. The SoundDock could charge an iPod while docked, however the lack of a direct input or pass-through Dock Connector means that the iPod cannot sync while being used in the SoundDock. [20]
The first 2.1 audio system from Bose was the "Lifestyle 10", which was released in 1990. The Lifestyle 10 included a single-disk CD player, an AM/FM radio and "Zone 2" RCA outputs which could be configured to output a different source to the primary speakers. A 6-disk magazine-style CD changer was introduced in 1996.
The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking with ridged, grooves or white stripes on the surface of lamp cord.
A power cable is an electrical cable, an assembly of one or more electrical conductors, usually held together with an overall sheath. The assembly is used for transmission of electrical power . Power cables may be installed as permanent wiring within buildings, buried in the ground, run overhead, or exposed.
The movable (less fixed) connector is classified as a plug (denoted P), [37] designed to attach to a wire, cable or removable electrical assembly. [38] This convention is currently defined in ASME Y14.44-2008, which supersedes IEEE 200-1975 , which in turn derives from the long-withdrawn MIL-STD-16 (from the 1950s), highlighting the heritage of ...
Standby power, also called vampire power [1], vampire draw, phantom load, ghost load, or leaking electricity, refers to how electronic and electrical appliances consume electric power. At the same time, they are switched off (but are designed to draw some power) or in standby mode. It only occurs because some devices claim to be "switched off ...
However, most other coaxial DC power connectors have no specified voltage association. Generic plugs are often named for the pin diameter they are designed to take. Many non-proprietary co-axial power plugs are 5.5 mm (0.22 in) in outside diameter (OD) and 9.5 mm (0.37 in) in length. Two pin sizes are standard in the jacks for this size plug ...
The first rubber-insulated cables for US building wiring were introduced in 1922 with US patent 1458803, Burley, Harry & Rooney, Henry, "Insulated electric wire", issued 1923-06-12, assigned to Boston Insulated Wire and Cable . These were two or more solid copper electrical wires with rubber insulation, plus woven cotton cloth over each ...