Search results
Results From The WOW.Com Content Network
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
Planetary differential used to drive a chart recorder c. 1961. The motors drive the Sun and annular gears, while the output is taken from the planet gear carrier. This gives 3 different speeds depending on which motors are on. Non-automotive uses of differentials include performing analogue arithmetic. Two of the differential's three shafts are ...
The AMC 20 was most often used with V8 engines in cars and Jeeps. ... Letter Code Open Differential Letter Code "Twin Grip" Ratio:1 Pinion:Ring Gear Teeth W-2.56: 16: ...
The "MN4" 4T40E is able to handle vehicles up to 4000 lb (1814 kg) GVWR. The final drive ratio can vary depending on the car's curb weight and engine power output. 3.91, 3.63, 3.29, 3.05, 3.69, and 3.42 are all of the available ratios used in the 4T40 (and 4T45) transmission; Made possible by using combinations selected from 3 different sprocket combinations (32/38, 35/35, 33/37) and 2 ...
The bell housing bolt pattern for the old AMC 196 Straight-6 engine is the same as for the more modern early 199 and 232 (used from 1964 to 1971), but the 196 had different dowel pin sizes. AMC's 1956 to 1966 V8s used a different bell housing bolt pattern that was slightly larger in diameter than the six cylinder bell.
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
Aisin is a Japanese corporation that develops and produces components and systems for the automotive industry, in particular automobile transmissions for passenger cars and SUVs, light commercial vehicles such as vans and light trucks. Aisin is a member of the Toyota Group of companies. Therefore, the transmissions of both manufacturers are ...
The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts. Dana offered two different limited slip differentials with the Dana 70, the "Powr-Lok" and the "Trac-Lok."