Search results
Results From The WOW.Com Content Network
These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.
The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
A Toploader transmission is a manually shifted gearbox design built in three-speed and four-speed configurations, introduced in 1963 by the Ford Motor Company to replace the BorgWarner T-10. It was used in most Fords and Mercurys from 1964 until 1973, as well as in some foreign models, and is officially designated the 3.03 three speed or Ford ...
From 1967 to 1981, the Borg-Warner 35 transmission was also used in the 6-cylinder Australian Chryslers, Valiants, Chargers and Centuras. The specification-change from the Torqueflite automatic transmission [11] to the Borg-Warner 35 transmission was due to a requirement for more local content. The Borg-Warner 35 transmission was used behind ...
The 3HP is a 3-speed Automatic transmission family with a hydrodynamic Torque converter with hydraulic control for passenger cars from ZF Friedrichshafen AG.In selector level position "P", the output is locked mechanically.
Roto's disadvantage was the 2-3 range or 1-2 gear change because it is not only a huge ratio jump from 2-3 range or 1-2 shift from 2.93 to 1.56, but also there is no fluid slippage in the coupling because the coupling drains (four-tenths of a second) to engage or apply the front clutch and so the trans goes to full mechanical connection.
The THM400 was the first three-speed, Simpson-geared automatic to use overrunning clutches for both first and second gear reaction, a feature that eliminated the need to coordinate the simultaneous release of a band and application of a clutch to make the 2-3 gear change. Owing to this feature, as well as the use of a large, multi-plate clutch ...
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.