Search results
Results From The WOW.Com Content Network
Oil discharge monitoring equipment (ODME) is based on a measurement of oil content in the ballast and slop water, to measure conformance with regulations. [1] The apparatus is equipped with a GPS, data recording functionality, an oil content meter and a flow meter. [2]
A ballast regulator at work in Spain. A ballast regulator (also known as a ballast spreader or ballast sweeper) is a piece of railway maintenance equipment used to shape and distribute the gravel track ballast that supports the ties in rail tracks. They are often used in conjunction with ballast tampers when maintaining track.
An axial-flow pump for industrial use. An axial-flow pump, or AFP, is a common type of pump that essentially consists of a propeller (an axial impeller) in a pipe.The propeller can be driven directly by a sealed motor in the pipe or by electric motor or petrol/diesel engines mounted to the pipe from the outside or by a right-angle drive shaft that pierces the pipe.
Temperatures in this area are much lower due to the cooling of the sea. If this extremely cathodic region is placed close to an anodic source (e.g. a corroding ballast pipe), cathodic blistering may occur especially where the epoxy coating is relatively new. Mud retained in ballast water can lead to microbial corrosion. [4]
The same report lists the following as some drawbacks to the double-hull design, including more expensive to build, [11] higher canal and port expenses, [11] ballast tank ventilation difficult, [11] ballast tanks need continual monitoring and maintenance, [11] increased transverse free surface, [11] more surfaces to maintain, [11] explosion ...
The problem with ballast tractors was the weight of ballast itself weighted over 10, 20 or even 40 tons in some scenarios. Other designs also included sleeping cabins in the ballast for the drivers and the crew for longer journeys and harsh weather conditions, [ 5 ] This made the height of the tractors increase significantly, these units are ...
The permit sets numeric ballast water discharge limits for commercial vessels 79 feet (24 m) in length or greater. The limits are expressed as the maximum acceptable concentration of living organisms per cubic meter of ballast water. Approximately 69,000 vessels, both domestic and foreign flagged, are covered by the permit. [22]
Combined with water in the ballast, these fines stick together, making the ballast like a lump of concrete. This hinders both track drainage and the flexibility of the ballast to constrain the track as it moves under traffic. [2] Ballast cleaning removes this worn ballast, screens it and replaces the "dirty" worn ballast with fresh ballast.