Search results
Results From The WOW.Com Content Network
The primary difference between a computer algebra system and a traditional calculator is the ability to deal with equations symbolically rather than numerically. The precise uses and capabilities of these systems differ greatly from one system to another, yet their purpose remains the same: manipulation of symbolic equations.
A data path is a collection of functional units such as arithmetic logic units (ALUs) or multipliers that perform data processing operations, registers, and buses. [1] Along with the control unit it composes the central processing unit (CPU). [1] A larger data path can be made by joining more than one data paths using multiplexers.
Karnaugh maps are used to simplify real-world logic requirements so that they can be implemented using the minimal number of logic gates. A sum-of-products expression (SOP) can always be implemented using AND gates feeding into an OR gate , and a product-of-sums expression (POS) leads to OR gates feeding an AND gate.
Delay calculation is the term used in integrated circuit design for the calculation of the gate delay of a single logic gate and the wires attached to it. By contrast, static timing analysis computes the delays of entire paths, using delay calculation to determine the delay of each gate and wire.
Logic optimization is a process of finding an equivalent representation of the specified logic circuit under one or more specified constraints. This process is a part of a logic synthesis applied in digital electronics and integrated circuit design. Generally, the circuit is constrained to a minimum chip area meeting a predefined response delay.
A gate equivalent (GE) stands for a unit of measure which allows specifying manufacturing-technology-independent complexity of digital electronic circuits.For today's CMOS technologies, the silicon area of a two-input drive-strength-one NAND gate usually constitutes the technology-dependent unit area commonly referred to as gate equivalent.
Defuzzification is the process of producing a quantifiable result in crisp logic, given fuzzy sets and corresponding membership degrees. It is the process that maps a fuzzy set to a crisp set. It is typically needed in fuzzy control systems.
To achieve better performance in the same area or the same performance in a smaller area, multiplier designs may use higher order compressors such as 7:3 compressors; [8] [7] implement the compressors in faster logic (such transmission gate logic, pass transistor logic, domino logic); [13] connect the compressors in a different pattern; or some ...