Ads
related to: 2004 f 150 cv axle replacement
Search results
Results From The WOW.Com Content Network
The Dana Holding Corporation manufactured the TTB axle for Ford. It uses a universal joint in the center that allows the wheels to move independently of each other. The differential is offset to the driver's side, and a slip yoke is used on the long axle side to allow the shaft to change length.
The 10th generation Ford F-150 offered this axle in the light-duty F-250 trucks from 1997 to 1999. For model year 2000 - 2004 trucks, the F-150 7700 offered this axle and the F-250 light duty was discontinued. At least till 2011 the 12 bolt semi float was still found with the heavy duty f-150.
While the first-generation Lightning chassis was a hybrid of the F-150 and F-250, to save weight and lower its cost, the second-generation adopted the stock F-150 frame. To improve handling, while the stock short/long arm front suspension configuration was used, the Lightning was lowered one inch with a 31mm stabilizer bar; the rear solid axle ...
Ford released an updated version in both solid and IRS form for 2015+ Mustangs and F-150. The most apparent difference is a 12 bolt cover instead of the traditional 10. The super 8.8 also uses larger bearings,longer pinion with larger nut, and most significantly 34 spline axles or half shafts.
The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.
A Rzeppa-type CV joint. A constant-velocity joint (also called a CV joint and homokinetic joint) is a mechanical coupling which allows the shafts to rotate freely (without an appreciable increase in friction or backlash) and compensates for the angle between the two shafts, within a certain range, to maintain the same velocity.