Ads
related to: dodge front hub assembly
Search results
Results From The WOW.Com Content Network
Dodge used a Dana 60 up to 2002. 3rd Generation Dodge Rams dropped the Dana 60 in favor of AAM (American Axle & Manufacturing) axles. Ford still uses the Dana 60 front axle. Manufactured in both Kingpin and Ball joint variations, "standard" (low pinion) and "reverse cut" rotation (high pinion) variations and open and limited slip, and locking ...
International started using Dana 70 front axles in the late 1960s. Both companies used Dana 70 front axles until the mid-1970s (Dodge W300 pickup up until 1978, discontinued in 1979). All of these Dana 70 front axles were closed knuckle, with king pins and had a GAWR of 6000 lbs. Like the rear Dana 70 axles, the Dana 70 front axle started out ...
The hub assembly is located between the brake drums or discs and the drive axle. A wheel is bolted on it. Depending on the construction, the end of the hub comes equipped with the splined teeth. They mate the teeth on the axle shaft. The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate.
Dodge pioneered the extended-cab pickup with the introduction of the Club Cab for 1973. Available with either a 6.5 ft (2.0 m) or 8 ft (2.4 m) Sweptline bed, the Club Cab was a two-door cab with small rear windows which had more space behind the seats than the standard cab, but was not as long as the four-door crew cab.
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
Get the Boydton, VA local weather forecast by the hour and the next 10 days.