Search results
Results From The WOW.Com Content Network
bolt circle: BCD or B.C.D. bolt circle diameter: BHC bolt hole circle Same definition as the bolt circle diameter BHCS: button head cap screw: Like an SHCS but with a button head. BHN: Brinell hardness number: BoM or BOM: bill of materials: Also called a list of materials (LM or L/M). Overlaps a lot in concept with a parts list (PL or P/L ...
With straightedge and compass, a diameter of a given circle can be constructed as the perpendicular bisector of an arbitrary chord. Drawing two diameters in this way can be used to locate the center of a circle, as their crossing point. [2] To construct a diameter parallel to a given line, choose the chord to be perpendicular to the line.
Diagram showing the path of a driver performing a U-turn.A vehicle with a smaller turning diameter will be able to perform a sharper U-turn. The turning radius (alternatively, turning diameter or turning circle) of a vehicle defines the minimum dimension (typically the radius or diameter) of available space required for that vehicle to make a semi-circular U-turn without skidding.
The outside diameter of a gear is the diameter of the addendum (tip) circle. In a bevel gear it is the diameter of the crown circle. In a throated worm gear it is the maximum diameter of the blank. The term applies to external gears, this is can also be known from major diameter. [1]
Compasses are usually made of metal or plastic, and consist of two "legs" connected by a hinge which can be adjusted to allow changing of the radius of the circle drawn. . Typically one leg has a spike at its end for anchoring, and the other leg holds a drawing tool, such as a pencil, a short length of just pencil lead or sometimes a
The tangent line through a point P on the circle is perpendicular to the diameter passing through P. If P = (x 1, y 1) and the circle has centre (a, b) and radius r, then the tangent line is perpendicular to the line from (a, b) to (x 1, y 1), so it has the form (x 1 − a)x + (y 1 – b)y = c.
Draw the diameter of the circle by joining points and with a straight line ¯. Draw the Mohr Circle . The centre O {\displaystyle O} of the circle is the midpoint of the diameter line A B ¯ {\displaystyle {\overline {AB}}} , which corresponds to the intersection of this line with the σ n {\displaystyle \sigma _{\mathrm {n} }} axis.
The most famous of these problems, squaring the circle, otherwise known as the quadrature of the circle, involves constructing a square with the same area as a given circle using only straightedge and compass. Squaring the circle has been proved impossible, as it involves generating a transcendental number, that is, √ π.