Ad
related to: wooden retaining wall instructions images on youtube
Search results
Results From The WOW.Com Content Network
Asphalt and sandbag revetment with a geotextile filter. A revetment in stream restoration, river engineering or coastal engineering is a facing of impact-resistant material (such as stone, concrete, sandbags, or wooden piles) applied to a bank or wall in order to absorb the energy of incoming water and protect it from erosion.
A basement wall is thus one kind of retaining wall; however, the term usually refers to a cantilever retaining wall, which is a freestanding structure without lateral support at its top. [2] These are cantilevered from a footing and rise above the grade on one side to retain a higher level grade on the opposite side.
Construction materials commonly used include wood pilings, commercially developed vinyl products, large boulders stacked to form a wall, or a seawall built of concrete or another hard substance. Coastal property owners typically seek to develop bulkheads in an attempt to slow large landslide erosion caused by wave action.
Comparison of a ha-ha (top) and a regular wall (bottom). Both walls prevent access, but one does not block the view looking outward. A ha-ha (French: hâ-hâ [a a] ⓘ or saut de loup [so dÉ™ lu] ⓘ), also known as a sunk fence, blind fence, ditch and fence, deer wall, or foss, is a recessed landscape design element that creates a vertical barrier (particularly on one side) while preserving ...
wall-plates (at the top of timber-framed walls that support the trusses and joists of the roof). When jettying, horizontal elements can include: The jetty bressummer (or breastsummer), where the main sill (horizontal piece) on which the projecting wall above rests, stretches across the whole width of the jetty wall. The bressummer is itself ...
Building a palisade wall for the fort at Jamestown, Virginia The Golden Plow Tavern in York, PA, is a very unusual American building. It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America.
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.