When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. List of automotive light bulb types - Wikipedia

   en.wikipedia.org/wiki/List_of_automotive_light...

   12 V & 24 V: 21 W BAY9s H27W/1 1 12 V: 27W PG13 USA ANSI № 880 H27W/2 1 12 V: 27 W PGJ13 USA ANSI № 881 HB3 1 12 V: 60 W P20d 90° USA, Japan ANSI № 9005 ECE nominal luminous flux: 1700 lm ±15% HB3A 1 12 V: 60 W P20d 180° USA ANSI № 9005XS HB4 1 12 V: 51 W P22d 90° USA, Japan ECE nominal luminous flux:1000 ± 15% ANSI № 9006 HB4A 1

3. Fluorescent-lamp formats - Wikipedia

   en.wikipedia.org/wiki/Fluorescent-lamp_formats

   The energy-saving T12 lamps are made to operate on ballasts designed for 40-watt F40T12 lamps, though some F40T12 ballasts are not be designed to operate these lamps, and can overheat if energy-saving lamps are used. Running an energy-saving T8 tube with a ballast for T12 will reduce lamp life and can increase energy consumption. [9]

4. GU24 lamp fitting - Wikipedia

   en.wikipedia.org/wiki/GU24_lamp_fitting

   The design was initiated by the U.S. EPA and the Lighting Research Center in 2004, in order to facilitate the deployment of compact fluorescent light bulbs with replaceable ballasts. [ 1 ] The GU24 fitting is compliant with a 2008 ruling by the California Energy Commission under Title 24 ( California Building Standards Code ) to require high ...

5. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   Twist-lock 120/230-volt MR16 halogen lighting of 35/50 watt, since the mid-2000s. Also used for compact fluorescents and LED lamps. GZ10: 7004-120-1: 10 mm: Twist-lock 120/230-volt MR16 halogen lighting of 35/50 watt, differs from GU10 by use of a dichroic reflector. GZ10 fixtures can use GU10 bulbs, but not vice versa. G12: 7004-63-2: 12.0 mm ...

6. Electrical ballast - Wikipedia

   en.wikipedia.org/wiki/Electrical_ballast

   The ballast in such systems can equally be a resistor. A number of fluorescent lamp fittings used a filament lamp as the ballast in the late 1950s through to the 1960s. Special lamps were manufactured that were rated at 170 volts and 120 watts. The lamp had a thermal starter built into the 4 pin base.

7. Multifaceted reflector - Wikipedia

   en.wikipedia.org/wiki/Multifaceted_reflector

   These lamps use a bi-pin connector for power: 12-volt MR11 bulbs usually use a GU4 base, and 12-volt MR16 bulbs usually use a GU5.3 base. The common 12-volt MR16 lamps, therefore, require a ferromagnetic or electronic transformer —sometimes misnamed as a ballast —to convert the 120- or 230-volt mains voltage to the extra-low voltage ...