Search results
Results From The WOW.Com Content Network
The slug is a derived unit of mass in a weight-based system of measures, most notably within the British Imperial measurement system and the United States customary measures system.
{{convert|123|cuyd|m3+board feet}} → 123 cubic yards (94 m 3; 40,000 board feet) The following converts a pressure to four output units. The precision is 1 (1 decimal place), and units are abbreviated and linked.
The reason for associating the deprecation of the U.S. survey foot with the modernization of the NSRS is that the biggest impact of the uniform adoption of the international foot will be for users of the NSRS, due to very large coordinate values currently given in U.S. survey feet in many areas of the U.S. Impacts related to the change to ...
This corresponds to a well-stacked woodpile, 4 feet deep by 4 feet high by 8 feet wide (122 cm × 122 cm × 244 cm), or any other arrangement of linear measurements that yields the same volume. A more unusual measurement for firewood is the "rick" or face cord .
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
The mile (Mil) is thus about 963 or 1146 meters (3160 or 3760 ft)—approximately six or seven tenths of a mile, and significantly shorter than the modern statute or land mile of 5280 ft or 1760 yd (approximately 1.6 km). The precise width of the etzba (finger) has been a subject of controversy among halakhic authorities. The best known are ...
For example, "five tenths," is typically a measurement or tolerance of five ten-thousandths of an inch, and written as 0.0005 inches. "Three tenths," as another example, is written as 0.0003 inches. [9] Machining "to within a few tenths" is often considered very accurate, and at or near the extreme limit of tolerance capability in most contexts.
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...