Ads
related to: aftermarket ecm for harley davidson fuel injection system work
Search results
Results From The WOW.Com Content Network
This is the default pre-loaded code from Bowling and Grippo. It is a simple and effective fuel injection controller with an 8x8 fuel table for speed density or alpha-n. Narrow band or wide band oxygen sensors can be used for closed loop control, and an on/off idle valve may be used. MS1/Extra (MegaSquirt 'n Spark-Extra) [7]
An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems.
Motronic is the trade name given to a range of digital engine control units developed by Robert Bosch GmbH (commonly known as Bosch) which combined control of fuel injection and ignition in a single unit. By controlling both major systems in a single unit, many aspects of the engine's characteristics (such as power, fuel economy, drivability ...
Injection phase Partway through the pump stroke, the solenoid is energized, which closes the spill valve. The fuel is forced into the cylinder through the spray tip. Pressure reduction phase Toward the end of the pump stroke, the spill valve is re-opened, allowing the fuel to recirculate again and ending the injection phase.
Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.
The engine management system was first utilized on the Saab B204 and B234 "H" engines to monitor and control the fuel injection system and turbocharging pressure control. The Trionic 5.2 and 5.5 systems utilized the manifold absolute pressure (MAP) sensor and the intake air charge temperature sensor to calculate the fuel injection curves, while ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
An ECU from a Geo Storm. An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.