Search results
Results From The WOW.Com Content Network
The oil pump is an internal combustion engine part that circulates engine oil under pressure to the rotating bearings, the sliding pistons and the camshaft of the engine. This lubricates the bearings, allows the use of higher-capacity fluid bearings , and also assists in cooling the engine.
Schematic diagram of a basic dry-sump engine lubrication system. The oil collects in sump (1), is withdrawn continuously by scavenge pump (2) and travels to the oil tank (3), where gases entrained in the oil separate and the oil cools. Gases (6) are returned to the engine sump. Pressure pump (4) forces the de-gassed and cooled oil (5) back to ...
Oil pump may refer to: Hydraulic pump, which pressurizes hydraulic fluid in a hydraulic system; Oil pump (internal combustion engine), a part of the lubrication system that pressurizes motor oil for distribution around the engine; Pumpjack, often used to pump oil out of wells; Submersible pump, often used to pump oil out of wells
A diagram of a pumpjack. A pumpjack is the overground drive for a reciprocating piston pump in an oil well. [1] It is used to mechanically lift liquid out of the well if there is not enough bottom hole pressure for the liquid to flow all the way to the surface. The arrangement is often used for onshore wells. Pumpjacks are common in oil-rich areas.
The oil is contained in a reservoir that connects to a small oil pump in the engine, which needs to be periodically refilled. Oil injection pump on a Yamaha DX100- just behind the carburettor (visible on the left) It is the primary component of two-stroke automatic lubrication system. Amount of two-stroke oil injected by the pump depends on the ...
When filling the workspace of the pumping pistons from "inside" (e.g., over a hollow shaft) it is called an inside impinged (but outside braced) radial piston pump (picture 1). If the workspace is filled from "outside" it's called an outside impinged radial piston pump (but inside braced) (picture 2) .
An internal oil pump is generally more difficult to replace, but that is dependent on the engine design. A wet sump design can be problematic in a racing car, as the large g force pulled by drivers going around corners causes the oil in the pan to slosh, gravitating away from the oil pick-up, briefly starving the system of oil and damaging the ...
By allowing the eccentric ring to pivot or translate relative to the rotor, the displacement can be varied. It is even possible for a vane pump to pump in reverse if the eccentric ring moves far enough. However, performance cannot be optimized to pump in both directions. This can make for a very interesting hydraulic-control oil pump.