Search results
Results From The WOW.Com Content Network
Cordite was used initially in the .303 British, Mark I and II, standard rifle cartridge between 1891 and 1915. [not verified in body] Shortages of cordite in World War I led to the creation of the "Devil's Porridge" munitions factory (HM Factory, Gretna) on the English–Scottish border, which produced around 800 tonnes of cordite per week. The ...
Firstly, cordite was not readily available except sealed in ammunition which was controlled issue. To remove the bullet from a .303 cartridge requires a minimum of 60 pounds pull with very little to grip on. Cordite is a very hard materiel and not easily chewed.(I have tried) and is almost totally insoluble in water (and hence body fluids).
The .600 Nitro Express is a slightly tapered walled, rimmed, centerfire rifle cartridge designed for use in single-shot and double rifles. [4]The cartridge fires a .620 in (15.7 mm) diameter, 900 gr (58 g) projectile with three powder loadings: the standard being 100 gr (6.5 g) of cordite at a muzzle velocity of 1,850 ft/s (560 m/s); a 110 gr (7.1 g) loading which generates a muzzle velocity ...
The .450/400 Nitro Express is a Nitro Express rifle cartridge that is produced in three case lengths: 2 3 ⁄ 8-inches, 3 inches and 3 1 ⁄ 4-inches, [2] and is intended for use in single shot and double rifles. The 3-inch and 3 1 ⁄ 4-inch versions are considered classic Nitro Express cartridges.
The term "Express" was coined by James Purdey in 1856, derived from the express train, to publicise the bullet velocity of his double rifles and became common parlance for many rifle cartridges. The addition of the word "Nitro" stemmed from the propellant used in these cartridges, cordite, which is composed of nitrocellulose and nitroglycerine.
Handgun propellants may reach peak pressure before the bullet leaves the cartridge case, while rifle propellants may move a bullet several inches before reaching peak pressure. [4]: 125 The motion and behavior characteristics of projectiles while under the influence of the gases produced by the propellant is known as internal ballistics. [13]
The .577/450 Martini–Henry is a rimmed, bottlenecked centerfire rifle cartridge derived from the .577 Snider, it was lengthened and bottlenecked. The .577/450 Martini–Henry was developed for use in the single shot Martini–Henry service rifle, originally loaded with blackpowder but later used cordite propellant.
VII centerfire .303 cartridge from WW II. Manufactured by Colonial Ammunition Company, New Zealand. The first cartridges for cannon were made up of gunpowder packed in a paper bag or case. For many years after the introduction of cannon the powder was introduced into the bore by means of a scoop-shaped ladle fixed to the end of a long stave.