Search results
Results From The WOW.Com Content Network
Industrial and consumer packages other than boxes can also be subjected to compression testing: drum, pail, bottle, tub [1] etc. Package components are also evaluated for compression resistance. [2] It is usually a laboratory test involving a special machine, a compression tester, to apply controlled compression on a test specimen.
Typical lectromechanical Universal Testing Machine Test fixture for three point flex test. A universal testing machine (UTM), also known as a universal tester, [1] universal tensile machine, materials testing machine, materials test frame, is used to test the tensile strength (pulling) and compressive strength (pushing), flexural strength, bending, shear, hardness, and torsion testing ...
Compression set A is defined as the percentage of original specimen thickness after the specimen has been left in normal (uncompressed) conditions for 30 minutes. C A, the compression set A is given by C A = [(t o - t i) / t o] * 100 where t o is the original specimen thickness and t i is the specimen thickness after testing. [2]
Tensile testing, also known as tension testing, [1] is a fundamental materials science and engineering test in which a sample is subjected to a controlled tension until failure. Properties that are directly measured via a tensile test are ultimate tensile strength , breaking strength , maximum elongation and reduction in area. [ 2 ]
Compression tests should normally be done with all spark plugs removed to maximize cranking speed. Cranking compression is a dynamic test of the actual low-speed pumping action, where peak cylinder pressure is measured and stored. A compression tester. Leak-down testing is a static test. Leak-down tests cylinder leakage paths.
The edge crush test is a laboratory test method that is used to measure the cross-direction crushing of a sample of corrugated board.It gives information on the ability of a particular board construction to resist crushing.
The Twist Compression Tester ("TCT") is a hydraulically operated bench-top apparatus used to evaluate the level of friction and/or wear between two materials under lubricated or non-lubricated conditions. Under controlled conditions, a rotating annular specimen is brought into contact with a non-rotating flat specimen.
Test compression is a technique used to reduce the time and cost of testing integrated circuits.The first ICs were tested with test vectors created by hand. It proved very difficult to get good coverage of potential faults, so Design for testability (DFT) based on scan and automatic test pattern generation (ATPG) were developed to explicitly test each gate and path in a design.