Search results
Results From The WOW.Com Content Network
Shunts are rated by maximum current and voltage drop at that current. For example, a 500 A, 75 mV shunt would have a resistance of 150 microohm, a maximum allowable current of 500 amps and at that current the voltage drop would be 75 millivolts. By convention, most shunts are designed to drop 50 mV, 75 mV or 100 mV when operating at their full ...
The Western Electric rules are decision rules in statistical process control for detecting out-of-control or non-random conditions on control charts. [1] Locations of the observations relative to the control chart control limits (typically at ±3 standard deviations) and centerline indicate whether the process in question should be investigated for assignable causes.
The various FBI mnemonics (for electric motors) show the direction of the force on a conductor carrying a current in a magnetic field as predicted by Fleming's left hand rule for motors [1] and Faraday's law of induction. Other mnemonics exist that use a right hand rule for predicting resulting motion from a preexisting current and field.
For intermediate-length lines on the order of 100 kilometres (62 miles), the limit is set by the voltage drop in the line. For longer AC lines, system stability becomes the limiting factor. Approximately, the power flowing over an AC line is proportional to the cosine of the phase angle of the voltage and current at the ends.
Various resistor types of different shapes and sizes. A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses.
While a hardware appliance can limit the rate for a given range of IP-addresses on layer 4, it risks blocking a network with many users which are masked by NAT with a single IP address of an ISP. Deep packet inspection can be used to filter on the session layer but will effectively disarm encryption protocols like TLS and SSL between the ...
Using a programmable thermostat's setback feature to limit heating or cooling in a temporarily unoccupied building does not waste as much energy as leaving the temperature constant. Using setback saves energy (5–15%) because heat transfer across the surface of the building is roughly proportional to the temperature difference between its ...
The primary rationale for instituting the reserve clause was to limit player salaries for the struggling NL by keeping players under team control. [3] Many of the players that the owners reserved for the 1880 season had been, at the time, the best-paid in the league, such as Cap Anson , Paul Hines , and Tommy Bond , and these players saw their ...