Search results
Results From The WOW.Com Content Network
The port and starboard sides of the vessel always refer to the same portion of the vessel's structure, and do not depend on the position of someone aboard the vessel. The port side is the side to the left of an observer aboard the vessel and facing the bow, towards the direction the vessel is heading when underway in the forward direction. The ...
Outboard: attached outside the ship. [20] Port: the left side of the ship, when facing forward (opposite of "starboard"). [1] Starboard: the right side of the ship, when facing forward (opposite of "port"). [1] Stern: the rear of a ship (opposite of "bow"). [1] Topside: the top portion of the outer surface of a ship on each side above the ...
A vessel heading in the direction of buoyage (e.g. into a harbour) and wishing to keep in the main channel should: keep port marks to its port (left) side, and; keep starboard marks to its starboard (right) side.
Amidships is the middle portion of the vessel in the fore and aft direction. Port is the left side of the vessel when facing the bow from on board. Starboard is the right side of the vessel when facing the bow from on board. Stern is the rear part of the hull.
Watercraft navigation lights must permit other vessels to determine the type and relative angle of a vessel, and thus decide if there is a danger of collision. In general, sailing vessels are required to carry a green light that shines from dead ahead to 2 points (22 + 1 ⁄ 2 °) abaft [note 1] the beam on the starboard side (the right side from the perspective of someone on board facing ...
On container ships the position of containers are identified by a bay-row-tier coordinate system. The bays illustrate the cross sections of the ship and are numbered from bow to stern. The rows run the length of the ship and are numbered from the middle of the ship outwards, even numbers on the port side and odd numbers on the starboard side ...
"The Liberty Ship and the T-2 Tanker (1941)". Ships of the Century. Marine Log. Archived from the original on 5 May 2008; Occupational Safety & Health Administration (OSHA) (2008-01-30). "Process: Tank Cleaning". Shipbuilding and Ship Repair - Hazards and Solutions. Department of Labor. Archived from the original on 1 April 2008
Graphical representation of the dimensions used to describe a ship. Dimension "b" is the beam at waterline.. The beam of a ship is its width at its widest point. The maximum beam (B MAX) is the distance between planes passing through the outer sides of the ship, beam of the hull (B H) only includes permanently fixed parts of the hull, and beam at waterline (B WL) is the maximum width where the ...