When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Lie-Nielsen Toolworks - Wikipedia

   en.wikipedia.org/wiki/Lie-Nielsen_Toolworks

   Lie-Nielsen Toolworks, Inc. is a family-owned business, established in 1981 and based in Warren, Maine. It manufactures a range of high quality hand tools, primarily for woodworking, based on traditional designs. [1] It is best known for its hand planes. Thomas Lie-Nielsen is the founder and CEO of Lie-Nielsen Toolworks.

3. Sliding T bevel - Wikipedia

   en.wikipedia.org/wiki/Sliding_T_bevel

   Different from the square, which is fixed and can only set a 90° angle, the sliding T bevel can set any angle and transfer it on another piece. The bevel gauge is composed of two elements connected with a thumbscrew or wing nut, which allows the blade to pivot and be locked at any angle. The handle is usually made of wood or plastic and the ...

4. Combination square - Wikipedia

   en.wikipedia.org/wiki/Combination_square

   [4] [2] The standard or square head has three adjacent flat faces, two of them meet square to one another, and the third face is angled away at 45°. When attached one face is parallel to the rule, one face is perpendicular, and one face is at 45°. The standard head usually incorporates a small spirit level and a small removable scriber. [4]

5. Dutchman (repair) - Wikipedia

   en.wikipedia.org/wiki/Dutchman_(repair)

   A rail repair dutchman is typically a 4–6-inch (100–150 mm) long piece of rail that is cut in advance for the purpose and carried by a section crew. If the gang finds a rail with a chipped or broken end, they remove the connector plates ( fishplates ), cut out the damaged section, replace it with the dutchman, and bolt the connectors back ...

6. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   In American English, a set screw is a screw that is used to secure an object, by pressure and/or friction, within or against another object, such as fixing a pulley or gear to a shaft. [ 1 ] [ 2 ] A set screw is normally used without a nut (which distinguishes it from a bolt ), being screwed instead in a threaded hole drilled in only one of the ...

7. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   Pocket screws have a wide washer head to spread the load for a firm bond, and prevent screwing too far into the joint and cracking the wood. The self tapping screws will grip any type of wood, but coarse threads are needed for softer wood and fine threads are needed for harder. [5]