Ads
related to: how to wire a 230 volt outletwireandcableyourway.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
The plug is three wire, earthed, rated at 10 A, 250 V and used for Class 1 applications; a slightly larger 16 A version also exists. The nominal pin dimensions of the 10 A version are: 1.5 mm thick by 6.4 mm wide, the line & neutral are 18 mm long, and the earth is 21 mm long. [22] It is similar to the Australian plug.
Australasian standard three pin plug, with part insulation on the Active/Line and Neutral pins. AS/NZS 3112 is the harmonised/joint Australian and New Zealand Standard for AC power plugs (male) and sockets (female). The International Electrotechnical Commission (IEC) "world plugs" website defines this design as Plug Type I'. The plug consists ...
The normal technical term (in both British and International English) for an AC power socket is socket-outlet, [4] but in non-technical common use a number of other terms are used. In British English the general term is socket, but there are numerous common alternatives, including power point, [5] plug socket, [6] wall socket, [7] and wall plug ...
The 20 A plug has a blade rotated 90° (opposite blade from what would be the "line" blade on a 2-15 or 5-15 plug. This prevents accidental insertion of plugs into outlets that use different voltages), and the 6-20R receptacle has a T-shaped hole to accept both 6-15P and 6-20P plugs (similar to the 5-20R receptacle accepting 5-15P and 5-20P plugs).
In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...
The cable is terminated on a television outlets, typically an F connector mounted on a face plate. If there are multiple outlets, an RF splitter is used to divide the signal among them; outlets on the splitter are connected to television outlets at each location (living room, rec room, bedrooms, den, for example).
Some terminations on wiring devices designed only for copper wire would overheat under heavy current load and cause fires when used with aluminium conductors. Revised standards for wire materials and wiring devices (such as the CO/ALR "copper-aluminium-revised" designation) were developed to reduce these problems. While larger sizes are still ...
"Switched socket-outlets and connectors with or without interlock" applies to self-contained products that combine within a single enclosure, a socket-outlet or connector according to IEC 60309-1 or IEC 60309-2 and a switching device, with a rated operating voltage not exceeding 1000 VDC or VAC and 500 Hz, and a rated current not exceeding 800 A.