Search results
Results From The WOW.Com Content Network
A common size for cells inside cordless tool battery packs. This size is also used in radio-controlled scale vehicle battery packs and some Soviet multimeters. 1 ⁄ 2-, 4 ⁄ 5 - and 5 ⁄ 4-sub-C sizes (differing in length) are also available. Soviet 332 type can be replaced with R10 (#4, 927, BF, U8) or 1.5 V elements from 3 V 2xLR10 packs.
Successive paper sizes in the series (A1, A2, A3, etc.) are defined by halving the area of the preceding paper size and rounding down, so that the long side of A(n + 1) is the same length as the short side of An. Hence, each next size is nearly exactly half the area of the prior size. So, an A1 page can fit two A2 pages inside the same area.
The C4 was designed to be a lighter and simpler replacement for the original Ford-O-Matic two speed transmission being used in smaller, less powerful cars. Ford used the term "SelectShift" because in the first C4's, placing the gear selector in D2 forced the transmission to start in second gear and then shift to third gear.
Named for the 1962 Ford Taunus V4 engine and Ford Cologne V6 engine built in Cologne, Germany.. 1.2/1.3/1.5/1.7L were mostly in European Cars. 1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of.
The codes given in the chart below usually tell the length and width of the components in tenths of millimeters or hundredths of inches. For example, a metric 2520 component is 2.5 mm by 2.0 mm which corresponds roughly to 0.10 inches by 0.08 inches (hence, imperial size is 1008).
A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
A size chart illustrating the ANSI sizes, superimposed on an "ANSI E" sheet In 1996, the American National Standards Institute adopted ANSI/ASME Y14.1 which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in (216 mm × 279 mm) Letter size which it assigned "ANSI A", intended for technical drawings ...