When.com Web Search

  1. Ad

    related to: random antenna wiring diagram chart 134 diagram 3 pole trailer

Search results

  1. Results From The WOW.Com Content Network
  2. Random wire antenna - Wikipedia

    en.wikipedia.org/wiki/Random_wire_antenna

    Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength (⁠ 1 / 4 ⁠ λ) or perhaps greater than a half (⁠ 1 / 2 ⁠ λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...

  3. ISO standards for trailer connectors - Wikipedia

    en.wikipedia.org/wiki/ISO_standards_for_trailer...

    Trailer connectors between the trailer and passenger car, light truck or heavy trucks with 12V systems. In Europe, both 7-pin (ISO 1724) and 13-pin (ISO 11446) are common. The 13-pin version being phased in is newer, provides more services than the 7-pin, a more positive locking and also better protection against moisture and contamination.

  4. Trailer connectors in Europe - Wikipedia

    en.wikipedia.org/wiki/Trailer_connectors_in_Europe

    Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...

  5. Trailer connectors in North America - Wikipedia

    en.wikipedia.org/wiki/Trailer_connectors_in...

    Light vehicles use a plethora of contacts, [8][9][10] but among these are two that are most common: 4-pin flat connector, often used for simpler trailers. 7-pin round blade connector, often used in caravans/RVs etc. Due to this there are unified vehicle outlets on the market that combine these two into a single module.

  6. J-pole antenna - Wikipedia

    en.wikipedia.org/wiki/J-pole_antenna

    The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.

  7. Trailer connectors in military organizations - Wikipedia

    en.wikipedia.org/wiki/Trailer_connectors_in...

    Trailer connectors in military organizations. A number of standards specific to military organizations exist for trailer connectors, the electrical connectors between vehicles and the trailers they tow that provide a means of control for the trailers. These can be found on surplus equipment sold for civilian use.

  8. Smith chart - Wikipedia

    en.wikipedia.org/wiki/Smith_chart

    The Smith chart (sometimes also called Smith diagram, Mizuhashi chart (水橋チャート), Mizuhashi–Smith chart (水橋スミスチャート), [1] [2] [3] Volpert–Smith chart (Диаграмма Вольперта—Смита) [4] [5] or Mizuhashi–Volpert–Smith chart), is a graphical calculator or nomogram designed for electrical and electronics engineers specializing in radio ...

  9. Monopole antenna - Wikipedia

    en.wikipedia.org/wiki/Monopole_antenna

    A monopole antenna is a class of radio antenna consisting of a straight rod-shaped conductor, often mounted perpendicularly over some type of conductive surface, called a ground plane. [1][2][3] The driving signal from the transmitter is applied, or for receiving antennas the output signal to the receiver is taken, between the lower end of the ...