Ad
related to: what is atm controller in computer network pdf notes ppt template
Search results
Results From The WOW.Com Content Network
An ATM controller (ATMC) is a system used in financial institutions to route financial transactions between ATMs, core banking systems and other banks. An ATMC is sometimes referred to as an "EFTPOS Switch". An ATM controller is key infrastructure in an interbank network.
IBM Turboways ATM 155 PCI network interface card. Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by the American National Standards Institute and International Telecommunication Union Telecommunication Standardization Sector (ITU-T, formerly CCITT) for digital transmission of multiple types of traffic.
Available bit rate (ABR) is a service used in ATM networks when source and destination don't need to be synchronized. ABR does not guarantee against delay or data loss. ABR mechanisms allow the network to allocate the available bandwidth fairly over the present ABR sources. ABR is one of five service categories defined by the ATM Forum for use ...
The services and protocols specified in IEEE 802 map to the lower two layers (data link and physical) of the seven-layer Open Systems Interconnection (OSI) networking reference model. IEEE 802 divides the OSI data link layer into two sub-layers: logical link control (LLC) and medium access control (MAC), as follows: Data link layer. LLC sublayer
Usage Parameter Control (UPC) and Network Parameter Control (NPC) are functions that may be performed in a computer network. UPC may be performed at the input to a network "to protect network resources from malicious as well as unintentional misbehaviour". [ 1 ]
An interbank network, also known as an ATM consortium or ATM network, is a computer network that enables ATM cards issued by a financial institution that is a member of the network to be used to perform ATM transactions through ATMs that belong to another member of the network. However, the functions which may be performed at the network ATM vary.
This AAL assumes that the data is sequential from the end user and uses the Payload Type Indicator (PTI) bit to indicate the last cell in a transmission. Examples of services that use AAL 5 are classic IP over ATM, Ethernet Over ATM, SMDS, and LAN Emulation (LANE). AAL 5 is a widely used ATM adaptation layer protocol.
In computer networking, the Point-to-Point Protocol over ATM (PPPoA) is a layer 2 data-link protocol typically used to connect domestic broadband modems to ISPs via phone lines. It is used mainly with DOCSIS and DSL carriers, by encapsulating PPP frames in ATM AAL5. Point-to-Point Protocol over Asynchronous Transfer Mode (PPPoA) is specified by ...