When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   There is a variant for half-letter size pages (8 + 1 ⁄ 2 by 5 + 1 ⁄ 2 inches or 220 mm × 140 mm), whose three rings are 2 + 3 ⁄ 4 inches (70 mm) apart. "Ledger" size binders hold 11-by-17-inch (28 by 43 cm) paper, and may use standard 3-ring spacing or multiple additional rings.

3. Loose leaf - Wikipedia

   en.wikipedia.org/wiki/Loose_leaf

   In North America, 3-hole binders for letter-size papers typically have a width of 1/2 inch, 1 inch, 1.5 inches, 2 inches, 3 inches or 4 inches; in ISO system, binders typically have a width of less than 3 cm. “Discbound” loose leaf systems, which uses separate “discs” to hold covers and pages. Staples and Office Depot sell discbound ...

4. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   Standard sizes are 4.8 mm (3 ⁄ 16 in) (for 16 sheets of 20# paper) up to 51 mm (2 in) (for 425 sheets). Spine lengths are generally 280 mm (11 in) to match the length of letter-size paper. Spine lengths are generally 280 mm (11 in) to match the length of letter-size paper.

5. Bookbinding - Wikipedia

   en.wikipedia.org/wiki/Bookbinding

   This type of binding uses either a 3:1 pitch hole pattern with three holes per inch or a 2:1 pitch hole pattern with two holes per inch. The three to one hole pattern is used for smaller books that are up to 9/16" in diameter while the 2:1 pattern is normally used for thicker books as the holes are slightly bigger to accommodate slightly ...

6. Drivers targeted in emerging crime trend have one thing ... - AOL

   www.aol.com/drivers-targeted-emerging-crime...

   Texas law enforcement issued a word of warning to Ford truck owners after they arrested a trio of thieves who targeted the high-end truck model by stealing taillights.

7. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   The diameter of the holes varies between manufacturers, with typical values being 1 ⁄ 4 to 5 ⁄ 16 inch (6 to 8 mm). The 5 ⁄ 16 value is most commonly used, as it allows for looser tolerances in both ring binder and paper punching. The distance to the paper edge also varies, with 1 ⁄ 2 inch (13 mm) hole