Search results
Results From The WOW.Com Content Network
The driven frequency may be called the undamped resonance frequency or undamped natural frequency and the peak frequency may be called the damped resonance frequency or the damped natural frequency. The reason for this terminology is that the driven resonance frequency in a series or parallel resonant circuit has the value. [1]
Stubs are commonly used in antenna impedance matching circuits, frequency selective filters, and resonant circuits for UHF electronic oscillators and RF amplifiers. Stubs can be constructed with any type of transmission line: parallel conductor line (where they are called Lecher lines), coaxial cable, stripline, waveguide, and dielectric waveguide.
A common form is the resonant stub, a length of transmission line terminated in either a short circuit or open circuit, connected in series or parallel with a main transmission line. Planar transmission-line resonators are commonly employed for coplanar, stripline, and microstrip transmission lines. Such planar transmission-line resonators can ...
The frequency at which this equality holds for the particular circuit is called the resonant frequency. The resonant frequency of the LC circuit is =, where L is the inductance in henries, and C is the capacitance in farads. The angular frequency ω 0 has units of radians per second.
A tesla coil is a high-Q resonant circuit. Electrical resonance occurs in an electric circuit at a particular resonant frequency when the impedances or admittances of circuit elements cancel each other. In some circuits, this happens when the impedance between the input and output of the circuit is almost zero and the transfer function is close ...
Displayed is the situation for = %, at which = and =, i.e., two adjacent Lorentzian lines (dashed colored lines, only 5 lines are shown for clarity for each resonance frequency,) cross at half maximum (solid black line) and the Taylor criterion for spectrally resolving two peaks in the resulting Airy distribution (solid purple line, the sum of ...
Parallel RC circuit. The parallel RC circuit is generally of less interest than the series circuit. This is largely because the output voltage V out is equal to the input voltage V in — as a result, this circuit does not act as a filter on the input signal unless fed by a current source. With complex impedances:
Resonators may be both electromagnetic and acoustic. Coupling coefficients together with resonant frequencies and external quality factors of resonators are the generalized parameters of filters. In order to adjust the frequency response of the filter it is sufficient to optimize only these generalized parameters.