Search results
Results From The WOW.Com Content Network
Eccentric bottom bracket on a Burley tandem bicycle held in place with two set screws. The term is also used to refer to the device often used on tandem bicycles with timing chains, single-speed bicycles with a rear disc brake or an internal-geared hub, or any bicycle with vertical dropouts and no derailleur, to allow slight repositioning, fore and aft, of a bottom bracket to properly tension ...
The counter balance shafts have eccentric weights and rotate in the opposite direction to each other, which generates a net vertical force. The balance shaft was invented and patented by British engineer Frederick W. Lanchester in 1907. [1] [2] It is most commonly used in inline-four and V6 engines used in automobiles and motorcycles.
The Wankel engine has a spinning eccentric power take-off shaft, with a rotary piston riding on eccentrics on the shaft in a hula-hoop fashion, with the crown gear with one and a half times the number of teeth as on the eccentric shaft. Thus the Wankel is a 2:3 type of rotary engine, i.e., its housing's inner side resembles a two lobes oval ...
The standard unit is a single-shaft, double-bearing unit constructed with a sieving box, mesh, vibration exciter and damper spring. The screen framing is steel side plates and cross-members that brace static and dynamic forces. At the center of the side plates, two roller bearings with counterweights are connected to run the drive.
The input shaft drives an eccentric bearing that in turn drives the cycloidal disc in an eccentric, cycloidal motion. The perimeter of this disc is geared to a stationary ring gear and has a series of output shaft pins or rollers placed through the face of the disc. These output shaft pins directly drive the output shaft as the cycloidal disc ...
The eccentric shaft's main bearings and the inlet manifolds were fed by oil-injection lubrication, and the fuel-air mix also carried residual mist of oil from the interior of the rotors, which helped to lubricate the rotor tips. [7] DKW Hercules with the F&S engine that was developed by Garside to become the Norton motor
Sealed cartridge bottom brackets are normally two pieces, a unit holding the spindle and bearings that screws into the bottom bracket shell from the drive side and a screw-in support cup (often made of light alloy or plastic) that supports the spindle and bearing assembly on the non-drive side.
The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.