When.com Web Search

  1. Ads

    related to: weldmark oxygen regulator rebuild kit

Search results

  1. Results From The WOW.Com Content Network
  2. Pin Index Safety System - Wikipedia

    en.wikipedia.org/wiki/Pin_Index_Safety_System

    The pin index safety system uses a face seal between the cylinder valve and the associated yoke clamp. There are two holes in specific positions on the cylinder valve body below the outlet port , in positions associated with the gas mixture, which prevent connection of the cylinder to a yoke or pressure regulator with a mis-matched set of pins.

  3. Emergency oxygen system - Wikipedia

    en.wikipedia.org/wiki/Emergency_oxygen_system

    Pulling down on one oxygen mask starts the oxygen supply for that mask only. The entire system can usually be reset in the cockpit or in some other location in the aircraft. [citation needed] A decentralized gaseous system, often called a pulse oxygen system, [4] is used on some modern airliners such as the Boeing 787. These systems have a ...

  4. Oxy-fuel welding and cutting - Wikipedia

    en.wikipedia.org/wiki/Oxy-fuel_welding_and_cutting

    Fuel and oxygen tanks should be fastened securely and upright to a wall, post, or portable cart. An oxygen tank is especially dangerous because the gas is stored at a pressure of 21 MPa (3,000 psi; 210 atm)) when full. If the tank falls over and damages the valve, the tank can be jettisoned by the compressed oxygen escaping the cylinder at high ...

  5. Demand valve oxygen therapy - Wikipedia

    en.wikipedia.org/wiki/Demand_Valve_Oxygen_Therapy

    Demand Valve Oxygen Therapy (DVOT) is a way of delivering high flow oxygen therapy using a device that only delivers oxygen when the patient breathes in and shuts off when they breathe out. DVOT is commonly used to treat conditions such as cluster headache , which affects up to four in 1000 people (0.4%), [ 1 ] [ 2 ] [ 3 ] and is a recommended ...

  6. Flashback arrestor - Wikipedia

    en.wikipedia.org/wiki/Flashback_arrestor

    The flashback arrestors are suitable for most technical gases (fuel gases) such as acetylene, hydrogen, methane, propane, propylene and butane as well as oxygen and compressed air. Flashback arrestors have to be tested for gas non-return, for tightness and for gas flow by a qualified person depending on the country specific regulations.

  7. SolidOx - Wikipedia

    en.wikipedia.org/wiki/Solidox

    SolidOx was the brand name for welding equipment produced by Cleanweld Products for do-it-yourself [1] [2] welding enthusiasts from 1965 until at least the early 1980s; the SOLIDOX name was registered as a trademark in 1968.