Ad
related to: buzzing noise coming from speakers on car audio receiver without amp pre out only
Search results
Results From The WOW.Com Content Network
Squelch circuits used in two-way radios to cut out noise similarly have a feedback loop which turns off the audio when high frequency noise is detected. If the inaudible radio frequency (RF) transmitter signal is inadvertently coupled into the receiver's audio signal path, it can trigger the AGC or squelch circuit to reduce the gain.
The torsional deflection of a simple cylinder cannot radiate efficiently acoustic noise, but with particular boundary conditions the stator can radiate acoustic noise under torque ripple excitation. [8] Structure-borne noise can also be generated by torque ripple when rotor shaft line vibrations propagate to the frame [9] and shaft line.
So while threshold levels of for the microwave audio effect of 267mW/cm² for 1.3GHz and 5000mW/cm² 2.9GHz, respectively, were reported by Frey in 1961, for the peak amplitude (providing the pops) and would only give an average (sustained) power density of only 0.4mW/cm² and 2mW/cm² respectively [7] similar to current cellphones.
Mains hum, electric hum, cycle hum, or power line hum is a sound associated with alternating current which is twice the frequency of the mains electricity.The fundamental frequency of this sound is usually double that of fundamental 50/60 Hz, i.e., 100/120 Hz, depending on the local power-line frequency.
A rumble is a continuous deep, resonant sound, such as the sound made by heavy vehicles or thunder. [1] In the context of audio reproduction rumble refers to a low frequency sound from the bearings inside a turntable. This is most noticeable in low quality turntables with ball bearings. Higher quality turntables use slide bearings, minimizing ...
An example of a typical high-end stereo preamplifier.. A preamplifier, also known as a preamp, is an electronic amplifier that converts a weak electrical signal into an output signal strong enough to be noise-tolerant and strong enough for further processing, or for sending to a power amplifier and a loudspeaker. [1]
With radio noise present, if a radio source is so weak and far away that the radio signal in the receiver has a lower amplitude than the average noise, the noise will drown out the signal. The level of noise in a communications circuit is measured by the signal-to-noise ratio (SNR, S / N ), the ratio of the average amplitude of the ...
Johnson–Nyquist noise (thermal noise, Johnson noise, or Nyquist noise) is the electronic noise generated by the thermal agitation of the charge carriers (usually the electrons) inside an electrical conductor at equilibrium, which happens regardless of any applied voltage.