When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   The most common plumbing fixtures are: Bathtubs; Bidets; Channel drains; Drinking fountains; Showers; Sinks; Tap (connections for water hoses) . Tapware - an industry term for that sub-category of plumbing fixtures consisting of tap valves, also called water taps (British English) or faucets (American English), and their accessories, such as water spouts and shower heads.

3. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   A plug in sanitation is an object that is used to close a drainage outlet firmly. The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole.

4. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...

5. Faucet aerator - Wikipedia

   en.wikipedia.org/wiki/Faucet_aerator

   Three major components of an aerator are: housing, insert and rubber washer. A faucet aerator can be classified on the basis of its flow rate and the type of water stream (aerated, non-aerated, spray) it produces. In general, standard-sized aerators are available with female (M22x1) or male threading (M24x1).

6. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   Fender washer (US), penny washer, mudguard washer, or "repair washer" (UK) A flat washer with a particularly large outer diameter in proportion to its central hole. These are commonly used to spread the load on thin sheet metal, and are named after their use on automobile fenders. They can also be used to make a connection to a hole that has ...

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   The most common type of power driven tap is the "spiral point" plug tap, also referred to as a "gun" tap, whose cutting edges are angularly displaced relative to the tap centerline. A spiral point plug tap ("gun" tap). This feature causes the tap to continuously break the chip and eject it forward into the hole, preventing crowding.